Delta Faucet Drama

I had to fix this faucet. Symptoms: difficulty shutting off the water, not too leaky, but it was rough. The fix was to replace insides with a new ball from Home Depot. I got the expensive kit that fits Delta or another brand (Peerless?) and has a small tool to remove the crown. Definitely a good buy for an inital repair, or if you lost that tool.

The cheaper fix is to get the kit that’s only for the Delta 70.

The main advantage of this specific unit is that it uses the old fashioned Delta ball. The rubber parts wear out between 5 and 10 years, and need replacement, but the parts are pretty cheap.

The new Delta products seem to all use a cartridge system, which is both easier to replace, more expensive to replace, and lasts longer between maintenance tasks. My feeling is – the classic ball is more reliable. My mom has one from the 1970s; it’s the kitchen sink one. You can still get it through mail order, and it’s expensive, and no-frills.

This bathroom faucet unit is not as sturdy, but it’ll last with some care. That said, one of these can be seriously fucked up if you torque something too tight. The guts are made of copper pipe, not cast steel.

Only tips:

I had to do some damage to the cover/crown thing, using a pipe wrench to get the thing off. I’ll probably need to replace that next time, but, for now, it’s OK. I sanded it down a bit, so it’s not dangerous.

The whole thing, especially the washers, were coated in silicone plumber’s grease.

I cleaned out the aerator, but it might need some refurb. When you re-open the supply, leave the aerator out, because loose sediment is going to flow out.

Use a flashlight to peer into the little hole where you tighten the setscrew to hold the handle on. If you don’t have one, get one. This is a must-have tool.

admin
Author: admin

This is the server’s system administrator. This site is undergoing some changes.